A-300 Primer - Cement/Concrete Modifier in Smooth Grey

Description

Description: A high build elastomeric acrylic material designed to absorb the fiberglass matting and adhere to the primer first coat. For waterproofing concrete and plywood decks. Specially formulated acrylic resins and multidirectional chopped fiberglass unite to provide a tough yet flexible coating.

Characteristics

Use: As a flexible intermediate coating in the Fiberglass Mat Waterproofing System.

 

Coverage Rate

Position fiberglass over the entire area to be covered butting the seams together. Stop the fiberglass at all expansion joints to allow for the proper joint caulk if needed. Fray all outside edges of the fiberglass to insure penetration of the #1588 base coat resin. Pour the base coat resin on top of the fiberglass, completely saturating it using pressure from a 1/2" nap roller. Coverage is at 40-50 square feet per gallon. Roll entire area with an aluminum fiberglass roller to eliminate air bubbles and wrinkles. 

 

Uses and General Information

Surface Preparation: For maximum durability the surface must be clean, free of dirt, oil, chalk and other foreign matter. Concrete, concrete decks, floors and walk ways New concrete must age for a minimum of 30 days. Cool temperatures and high humidity may require a longer cure time. Remove all grease, oil and wax with T. S. P. solution. (One pound of T. S. P. to 1 gallon of water.) Scrub with stiff broom until surface is thoroughly clean. Rinse thoroughly with clear water. Then etch all unpainted cement with 1 part 10% muriatic acid to 1 part water. Allow to stand 10-15 minutes then rinse clean with water. A properly etched concrete surface should resemble the texture of fine or medium sandpaper. Let dry thoroughly before applying coating.  Store in a Clean Dry Place not below 55 degrees or above 90 degrees. Application Specifics Important weather guidelines: 1. Apply on warm, clear, sunny days. 2. Do not apply under foggy conditions. 3. Do not apply when rain is forecast within 24 hours. 4. Do not apply if temperatures are expected to drop below 50o F within 24 hours.

 

Product Warranty/Liability Disclaimer

• Since no control is exercised over product use,
AMERICRETE represents and warrants ONLY that the
products are of consistent quality within manufacturing
tolerances for a period of ONE year. NOTE: if Americrete
sealers are not used to seal the surface then there is NO
WARRANTY implied. Americrete sealers must be applied
to the substrate for Americrete to warranty material.
All sales are final. NO other oral or written representation
or statement of any kind, expressed or implied, now or
hereafter is authorized or warranted by AMERICRETE,
including those of marketability or fitness for a particular
purpose. Liability for breach of contract, negligence or on
any other legal basis is limited to the lesser cost of refund
or replacement of material proven to be defective.
AMERICRETE, will not be liable for special, incidental or
consequential damages, including for delays or lost profits.
There is no warranty for product installations, color
variations, product delamination or cracks in the surface
due to the substrate cracking. The end user shall
determine the suitability of the products for the intended
use and assumes all risks and liability in connection
therewith.

NOTE:

If litigation arises the party filing the complaint or
law suit will be responsible for all attorney fees and court
costs incurred by AMERICRETE, and all other costs
related to the investigation of the law suit and/or
complaint.

This warranty is effective August 1, 2007, and supersedes
any and all previous warranties, written or verbally
communicated Note: Americrete products are to be
applied only when surface temperatures are at 55oF or
higher, not to exceed 100oF. Do not apply when rain or
other precipitation is expected within 24 hours.