Heat Reflective Color Seal 

 

Advantages

• Solar Heat Reflective
• UV Resistant
• Fast Drying
• Water Base- Easy Clean-Up
• Chemical Resistant
• Alkali and Moisture Resistant
• Excellent Hide and Color Retention
• Passes ASTM D2047-82
• Resistant to Ponding Water

Uses

• Concrete Floors
• Pool Decks
• Patios
• Fiberglass Mess System
• Armor shield (Acrylic/Lath) Deck System
• Pool Texture Deck System
• Walls
• Stucco

 

Surface Preparation:

For maximum durability the surface must be clean,
free of dirt, oil, chalk and other foreign matter.
Concrete, concrete decks, concrete floors and concrete
walk ways. New concrete must age for a minimum of 30 days.
Cool temperatures and high humidity may require a
longer cure time. Remove all grease, oil and wax with
T.S.P. solution. (One pound of T.S.P. to 1 gallon of
water.) Scrub with stiff broom until surface is
thoroughly clean. Rinse thoroughly with clear water.
Then etch all unpainted cement with a-250 Acid
etching get, allow to stand five minutes then rinse
clean with water. After etching, neutralize acid with
baking soda or soda ash then rinse thoroughly with
water. A properly etched concrete surface should
resemble the texture of medium sandpaper. Let dry
thoroughly before applying coating.

 

Priming:

A-1150 Series may be used as its own primer. To use
as a primer, add 1 pint water to 1 gallon A-1150 Series.
Previously Painted Surfaces:
Clean all surfaces and roughen all glossy surfaces by
sanding. Remove all peeling, loose or blistered paint
by scraping and wire brushing. Remove all
chlorinated rubber and hydrocarbon finishes by
sandblasting. Clean all surfaces thoroughly with a
T.S.P solution and then rinse thoroughly with water.

 

Glossy Surfaces:

Roughen gloss by sanding; then wash with a T.S.P.
solution and rinse thoroughly with water.

 

Coverage:

Cool Pool A-1150 Series may be rolled, brushed or
sprayed. The coverage will vary, up to 300 square feet
per gallon on a smooth surface and between 100-250
square feet per gallon on a rough or textured surface.
(Product may be thinned with a small amount of water,
2 coats are recommended.)

 

Application:

Box and mix all containers together to insure
consistent color. Neatly cut-in all edges with a brush
and roll the main area using a 1/2" nap, good quality
roller cover. Be sure to spread evenly in a "V" pattern,
rolling in both directions. It is best not to apply in the
hot sun or above 80 degrees. Thinning slightly with
water and applying thin coats will help avoid streaks
in direct sun.

 

Drying Time:

Allow four (4) hours between coats and light foot
traffic. Normal foot traffic after twenty-four (24) hours.
No vehicle traffic with out sealer. Allow forty-eight
(48) hours before placing heavy objects on the
surface.

 

Clean-up:

Warm water and soap.

Temperature/Weather:

Do not install any Americrete product if the
temperature is below 55 degrees or in extreme heat.
Rain may damage uncured Americrete products. If
inclement weather threatens, cover deck to protect
new application. Do not allow any Americrete product
to FREEZE.